Choosing an excellent mechanism charcoal equipment is critical. Currently on the market charcoal machine equipment, charcoal machine process is basically the same, but the equipment is very different production,


Take the dryer as an example: the raw material should be dried before drying, so that the water content reduced to between 12% -4%. This requires the length of the dryer pipe, pipe diameter, pipe insulation performance, fan air volume, wind pressure, flow rate should be suitable for raw material drying requirements. Drying machine should be a water content of 35% of raw materials can be dried. Some dryer due to pipe length, wind pressure, air flow is not suitable for drying requirements. So 3-4 times to make raw materials drying, so not only a waste of human, material, electricity, fuel greatly increase the cost of carbon production, and very affect the next process - rod. At present, the sales mechanism of charcoal equipment manufacturers a lot of competition between the price war, greatly affecting product quality. Due to low product prices, some manufacturers, cut corners, so that product performance, product quality, can not guarantee. Therefore, please investors be careful, to shop around, to want to benefit, first of its profits.


Carbonization is the key link in the mechanism of charcoal production. The carbonization method is varied and can be divided into two categories: internal combustion method and dry distillation method. Only carbonization process requirements are different, the carbonization temperature should be 550 degrees - 600 degrees is appropriate, the early temperature should be slow, the kiln should be 15 hours as well, the machine for 2-3 hours, the early heating time is long, to prevent raw materials Stick damp, cracked. To ensure the quality of carbonization. Mechanism of charcoal carbonization is good or bad with the material rods are closely related to the general requirements of the density of raw materials should be greater than 1. Simple detection method to take a part of the raw material into the water after the formation of the sun in the proportion of more than 1, the proportion of floating is less than 1, the density is higher than the high quality of charcoal produced.